Installing the Remote Office 9150 unit
Required tools
This section identifies the tools you need to perform Remote Office 9150 unit
installation and maintenance tasks.
Hardware installation tools
You need the following tools to install the Remote Office 9150 unit, or to install
or replace DSP application or trunk interface modules:
n
an antistatic ESD wrist strap (recommended)
n
a Phillips (cross-head) screwdriver
n
a pen or pencil for
n
noting the installation location (if mounting on a wall)
n
noting cable lengths
n
labeling cables
n
cable tie wraps
n
cable identification labels
n
a tape measure
n
four wood screws if you want to mount the Remote Office 9150 unit on the
wall
Software installation or upgrade tools
In addition, if you are performing a first-time installation or a maintenance
upgrade, you need the following items:
n
the Remote Office Product CD-ROM
n
a PC with a CD-ROM drive or an Internet connection for obtaining
software, firmware, and documentation updates
n
a TFTP server application installed on the PC
The TFTP server is required for performing firmware upgrades. If a TFTP
server is currently not installed, you can obtain one from the Internet.
94
Standard 2.0
Remote Office 9150