Nortel Remote Office 9150 Installation And Administration Manual page 142

Hide thumbs Also See for Remote Office 9150:

Table of Contents

Installing the Remote Office 9150 unit

Connect the ADMIN connector on the Remote Office 9150 unit to the

administration PC as follows:

a. Connect the male 9-pin connector of the supplied RS-232 serial cable

b. Connect the other end to an available COM port on the PC.

Connect the Remote Office 9150 unit to the power source as follows:

a. Connect the four-pin plug on the power transformer to the POWER

b. Connect the AC cord to the AC power receptacle on the power

c. Plug the AC cord into a 110 V or 220 V uninterruptible power source

Proceed with "Powering up the Remote Office 9150 unit" on page 119.

to the ADMIN connector on the Remote Office 9150 unit.

Note: You may need to provide an RS-232 adapter if the available

RS-232 port on your PC does not match the connector on the serial

connector on the Remote Office 9150 unit.

Note: Ensure the arrow on the four-pin plug faces up.

transformer.

(UPS) or wall outlet.

Standard 2.0

Remote Office 9150