UltiMate 3000 Series:
SRD-3x00 Solvent Racks
5.3 Operational Settings
5.3.1 Turning the Degasser on or off (from the UltiMate 3000 System Pump)
When the SRD is connected to the pump, NCS-3500RS, or NCP-3200RS of an
UltiMate 3000 system and when the module is powered up, the SRD is powered from the
module. The degasser is ready for operation.
You can turn the degasser on or off:
•
From the front panel display of the pump
•
From Chromeleon if the module is operated from Chromeleon
•
By the standby button on the front panel display (→ page 13). Press and hold the button
for one second to allow the SRD to change the mode.
Observe the following:
•
Turning off the module to which the SRD is connected, also turns off the SRD. The same
applies to Standby mode.
•
Thermo Fisher Scientific recommends always leaving the degasser on.
5.3.1.1 Turning the Degasser on and off from the Pump Display
1. On the front panel display of the pump, show the function keys and select Menu. (For
details, see the Pump and/or NCS/NCP manuals.)
2. On the Main menu, select Preferences, and then select Degasser.
3. Select On (or Off) to turn on (or off) the degasser.
Page 32
Operating Instructions