Figure 28: Positioning The Sfp Handle In The Upright Position; Figure 29: Ejecting An Sfp Transceiver After Lowering The Sfp Handle To The Downwards Position - Allied Telesis AT-x220-28GS Installation Manual

4. Verify that the handle on the transceiver is in the upright position, as
shown in Figure 28. This secures the transceiver and prevents it from
being dislodged from the slot. If the transceiver is in a bottom slot verify
the handle is in the downright position.
Figure 28. Positioning the SFP handle in the upright position
SFP Transceiver
Handle
5. Eject SFP transceivers, as shown in Figure 29. First lower the SFP
transceiver handle, then gently remove the SFP transceiver. If the
transceiver is in a bottom slot, then raise the handle.
Figure 29. Ejecting an SFP transceiver after lowering the SFP handle
to the downwards position
6. Repeat steps 2 through 6 to install an additional SFP transceiver.
Note
Unnecessary removal and insertion of an SFP transceiver can lead
to premature failure.
For information on the cable specifications of the SFP, consult the
documentation shipped with the SFP.
2 5
2 7
F A U L T
P O W E R
C O N S O L U S B
E
O N
ER R
2 6
2 8
LA SE R PR
2 5
2 7
F A U L T
P O W E R
C O N S O L U S B
E
O N
ER R
2 6
2 8
LA SE R PR
AT-x220-28GS Switch Installation Guide
A C T
CL AS S 1
OD UC T
A C T
CL AS S 1
OD UC T
41