Positions Of The Switch On A Wall; Figure 16: Positioning The Switch On The Wall - Allied Telesis AT-x220-28GS Installation Manual

Positions of the
switch on a wall
Install the switch
on the wall
The switch may be installed on the wall with the front panel on the left or
right with the brackets placed diagonally as shown in Figure 16.
Do not install the switch with the front panel on the top or the bottom.
Figure 16. Positioning the switch on the wall
To install the switch on a wall, perform the following procedure:
1. If the rubber feet are attached to the bottom of the switch, remove
them with a screwdriver (Figure 13 on page 25), then turn the switch
back over.
2. Orient the brackets against the sides of the switch and secure them to
the unit with the 8 bracket screws included in the rack/wall mount kit.
You can either attach the brackets facing left or right as shown in
Figure 17 and Figure 18.
AT-x220-28GS Switch Installation Guide
29