Installing The Switch In An Equipment Rack; Figure 14: Attaching Rack Mount Brackets To The At-X220-28Gs Switch - Allied Telesis AT-x220-28GS Installation Manual

Chapter 2: Installation

Installing the switch in an equipment rack

26
These instructions show you how to install the switch in an equipment
rack. The rack mount kit is included in the packaging and includes two
rack mount brackets and eight bracket screws.
To install one of these switches in a 19-inch equipment rack, follow these
steps:
1. Review the procedure "Selecting a site for the switch" on page 21 to
verify that the selected site is suitable for your switch.
2. If rubber feet are attached to the base of the switch, remove them
(Figure 13 on page 25).
3. Attach the two rack mount brackets to the sides of the switch using the
eight bracket screws that come with the rack mount kit provided. See
"Unpacking the switch" on page 22.
Figure 14. Attaching rack mount brackets to the AT-x220-28GS
switch