Removal From Service And Dismantling - GIRBAU ED460 Installation Instructions Manual

10. REMOVAL FROM SERVICE AND DISMANTLING

CAUTION!
 Taking the dryer out of service must be performed by a specialised service or contractor.
Under no circumstances must the dryer be left unchecked.

 When it comes to handling and transporting the machine, the same precautions and regulations
must be taken into account as for the installation process.
On taking the dryer out of service
 Disconnect and mechanically lock the external switch. Remove all the supply cables.
 If the dryer is gas heated, close and mechanically lock the manual gas inlet valve . Remove gas supply
hoses.
 Remove the exhaust duct.
Dismantling
Most of the dryer's components are made with recyclable or recoverable materials.
The injected pieces bear information on the materials that were used to make them.
The main materials are:
 Steel plates
 Stainless steel plates
 Aluminium
 Glass
 Copper
Electronic components.

CAUTION!
In compliance with Directive 2002/96/EC on the management of waste from electronic devices, it
is the obligation of the manufacturer to warn that:
The electronic components installed in the machine must be dismantled and delivered to
treatment facilities authorised for this purpose.
Removal from service and dismantling
67
Code No. 549758
Rev. nº 10/0418