Positioning And Levelling The Machine; Anchoring The Dryer - GIRBAU ED460 Installation Instructions Manual

VERY IMPORTANT
Never disconnect the power supply until you have fully completed the cooling cycle, except in an emergency.
If the machine is running a cycle and the fan stops, the power supply is disconnected or the door is opened, the
heat accumulated in the heater box is released through the grille in the top cover as hot air. Therefore:
 Do not touch the upper cover rear area.
 Do not place any object or substance on the upper cover.
 Strictly observe the safety distances between the dryer and the ceiling and walls of the premises and any
fixtures and flammable objects therein.
Ensure a correct ventilation of the top and rear of the dryer, particularly in case of installing a partition wall
around the machine.

3.3. Positioning and levelling the machine

Remove the bolts securing the dryer to the base of the
crate.
Separate the machine from the crate.
On models ED260, ED340, ED460 and ED660 adjust the
levelling of the machine correctly by turning the dryer's feet
(Fig. 3.4/A).

3.4. Anchoring the dryer

In most installations, it is not considered necessary to anchor
the dryer.
If in particular cases it is considered appropriate to fasten the
dryer to the floor, the mounting holes at the base of the
packing case can be used.
Values of the measurements in Figure 3.5
mm
A
(in)
mm
B
(in)
C mm
(diam) (in)
The arrow indicates the front of the machine.
ED260 ED460 ED900
ED340 ED660 ED1250
720 924
(28.3) (36.4)
17 17
(0.7) (0.7)
11 11
(0.4) (0.4)
Location
1137
(44.8)
19
(0.7)
11
(0.4)
23
Fig. 3.4
Fig. 3.5
Code No. 549758
Rev. nº 10/0418