Safety Instructions - GIRBAU ED460 Installation Instructions Manual

WARNING – Risk of Fire:
WARNING – To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow
basic precautions, including the following:
 Clothes dryer installation must be performed by a qualified installer.
 Install the clothes dryer according to the manufacturer's instructions and local codes.
 Do not install a clothes dryer with flexible plastic venting materials. If flexible metal (foil type) duct is
installed, use duct that has been investigated and found acceptable for use with clothes dryers.
Flexible venting materials are known to collapse, be easily crushed, and trap lint. These conditions
will obstruct clothes dryer airflow and increase the risk of fire.
 To reduce the risk of severe injury or death follow all installation instructions.
SAVE THIS INSTRUCTIONS.
WARNING
TRANSPORT, INSTALLATION, INSPECTION, MAINTENANCE, REPAIR OR MODIFICATION
ROUTINES ON GIRBAU EQUIPMENT
1. The actions described in these instructions are strictly reserved for contractually AUTHORISED
TECHNICAL SERVICES (ATS) and personnel who have successfully completed training by Girbau
SA.
2. The company responsible for the Authorised Technical Service accepts full liability for the work done
and any possible consequences that may derive from it.
3. Any actions carried out by personnel who are not authorised by the manufacturer will be considered
to be improper and will result in the automatic voiding of the machine's warranty.
4. The manufacturer will not accept responsibility for any physical and/or material damage caused by
actions performed on the machine undertaken by unauthorised personnel.
5. Do not store or install the machine in areas exposed to the ELEMENTS or where it may be splashed
by water.
6. The room where the machine is located MUST comply with the environmental conditions (air venting,
temperature, humidity, etc.) specified in the technical specifications table. NEVER INSTALL THE
MACHINE IN ENVIRONMENTS where it will be splashed with water or where there is a very high
level of humidity in the atmosphere.
7. All installations required for the proper operation of the machine MUST be carried out by a duly
accredited Registered Installation Contractors, in compliance with the legal regulations applicable in
the country of use.
8. Once the corresponding operation has been performed, the ATS staff must perform the final
machine inspection.
9. Avoid carrying out any action on the machine without having first read and understood the machine's
Installation and Operating Manuals, paying special attention to the Safety Instructions.
10. In any action that modifies the values of the machine's specifications plate, it should be borne in
mind that:
- It is the responsibility of the ATS to check that the external installation for the machine has been
modified and adapted to the new requirements, particularly to those regarding ducting and
electrical protection.
- It is the responsibility of the ATS to update the specifications plate, in accordance with the new
operation conditions, once the final machine inspection has been performed.

Safety instructions

IMPORTANT SAFETY INSTRUCTIONS
4
Code No. 549758
Rev. nº 10/0418