Transporting With Packing Crate Using A Hoist; Separating The Machine From The Base Of The Packing Crate - GIRBAU ED460 Installation Instructions Manual

2.3.2. Transporting with packing crate using a hoist

Only for models ED260, ED340, ED460 and ED660
Before moving the machine, make sure the items to be
used are suitable and capable of bearing its weight.
See weights and measures in the table in Section 2.6.
Pass TWO slings inside the transport base as shown in
Figure 2.6. To prevent the machine from tipping
sideways excessively,
positioning instructions indicated in the detail of the
figure.
The angle between the slings at the top should never
be greater than that indicated in the figure.

2.3.3. Separating the machine from the base of the packing crate

A three-man team is recommended to perform this operation. Before moving the machine, make sure the items
to be used are suitable and capable of bearing its weight.
The weight of the machine and the position of its centre of gravity indicated in Section 2.4 and Figures 2.5 and
2.6 must be taken into account at all times.
The machine comes fully assembled in a single crate.
Tools needed
 Fitting covers: ............. Torx T25 screwdriver.
 Attaching to the base: 17 mm (11/16 in) open end spanner
 Levelling the feet: ....... 7 mm set spanner
Models ED260, ED340, ED460 and ED660
Receipt, storage and transport
take care to follow
Fig. 2.7
the
Models ED990 and ED1250
17
Fig. 2.6
Fig. 2.8
Code No. 549758
Rev. nº 10/0418