Location - GIRBAU ED460 Installation Instructions Manual

3. LOCATION

CAUTION!
THE LOCATIONS WHERE THE MACHINES ARE TO BE SITED MUST COMPLY WITH THE LEGAL
REGULATIONS IN FORCE IN THE COUNTRY OR AREA WHERE THESE MACHINES ARE TO BE USED.
PROVISION SHOULD BE MADE FOR AN ERGONOMIC USE OF THE MACHINE, ESPECIALLY FOR
LOADING, AND UNLOADING OPERATIONS, AND FOR ACCESS TO THE CONTROLS.
NEVER INSTALL THE DRYER IN AREAS CONTAINING EXPLOSIVE OR HIGHLY FLAMMABLE
ENVIRONMENTS.
CAUTION!
THE MANUFACTURER IS OBLIGED TO ADVISE YOU THAT FAILURE TO INSTALL THIS MACHINE
PROPERLY MAY PRODUCE A FAULT OR CAUSE POOR MACHINE OPERATION RESULTING IN
SERIOUS BODILY INJURY. THE MANUFACTURER DECLINES ALL RESPONSIBILITY IN THESE CASES.
CAUTION!
THE DRYER MUST BE INSTALLED ON A FLAT FLOOR SURFACE THAT IS PERFECTLY EVEN AND
CAPABLE OF SUPPORTING THE WEIGHT OF THE MACHINE.
ANY INFLAMMABLE SUBSTANCES COVERING THE FLOOR SUCH AS RUGS AND CARPETS MUST BE
REMOVED.
A FIRE EXTINGUISHER MUST BE PLACED INSIDE THE PREMISES, IN A PLACE EASILY VISIBLE AND
EASILY ACCESSIBLE. FOLLOW THE RULES OF THE COUNTRY WHERE THE DRYER IS INSTALLED TO
LEARN THE TYPE AND LOCATION OF THE FIRE EXTINGUISHER.
CAUTION!
SPECIFIC WARNING FOR GAS-HEATED DRYERS.
BEFORE CARRYING OUT THE INSTALLATION OF THE MACHINE, CHECK THAT THE LOCAL GAS
SUPPLIES (TYPE OF
REQUIREMENTS.
THIS APPLIANCE MUST BE INSTALLED IN ACCORDANCE WITH THE RULES IN FORCE, AND MUST BE
USED ONLY IN AREAS THAT ARE ADEQUATELY VENTILATED. CONSULT THE INSTRUCTIONS
BEFORE INSTALLING AND USING THIS APPLIANCE.
CAUTION!
SPECIFIC WARNING FOR MACHINES INSTALLED ON USA/CANADA PREMISES.
TO REDUCE THE RISK OF FIRE, THIS MACHINE MUST BE INSTALLED ON A CONCRETE FLOOR
WITHOUT ANY COVERING.
DANGER!
DRY CLEANING MACHINES
THE INSTALLATION OF DRY CLEANING MACHINES AND DRYERS WITH GAS HEATING IN THE SAME
PREMISES IS INCOMPATIBLE.
SOME DRY CLEANING MACHINES IN POOR CONDITION MAY EMIT GASES FROM SOLVENTS INTO THE
LOCAL ATMOSPHERE, AND THESE, ON INTERACTING WITH TEMPERATURE, MAY BECOME HIGHLY
TOXIC AND CORROSIVE GASES. EXTREME CARE MUST BE TAKEN IN THE MAINTENANCE OF THESE
MACHINES.
Location
GAS AND PRESSURE) ARE COMPATIBLE WITH
20
THE EQUIPMENT
Code No. 549758
Rev. nº 10/0418