Managing Power Output - Intermec CK1 User Manual

Chapter 5 — Managing the CK1

Managing Power Output

This section explains how to use the CK1 Power screen to
extend battery life. From the CK1 Power screen you can:
• check the power source.
• check the power status.
• check the remaining power.
• set how long the CK1 is idle before it goes to Standby mode.
• set how long the CK1 will be in Standby mode.
To manage power from the CK1 Power screen
1 From the Main screen, enter the System Setting screen. For
help, see "Entering the System Setting Screen" on page 24.
2 Press
Power screen appears.
• Read the Power source line to find out if the CK1 is
currently being powered by a battery or dock. If the CK1 is in
a dock and the Power source line reads battery, make sure
the dock is plugged in to AC power.
• Read the Power status line to find out the status of the power
source: charging or discharging. If the CK1 is in a dock and
the Power status line reads as discharging, make sure the
dock is plugged in to AC power.
88
to highlight the Power icon, and press Enter. The
Setting
Power
Power source: Battery
Power status: Discharging
Remaining power: 48%
Enable APM.
Slow after 2 sec.
Standby
1 2 3 5 10 mins.
CK1 Handheld Computer User's Manual