Starting A New Service Interval; Standard Inspection And Maintenance Operations; Checking The Water Pressure - REMEHA Quinta Pro 30 Installation, User And Service Manual

Fig.60

Starting a new service interval

5x
...x
...x
3x
10.3

Standard inspection and maintenance operations

123157 - v.12 - 07022018
10.2.2
For an interim service it is advisable to read out in the boiler service menu
what maintenance service should be carried out. Use the indicated
Remeha service kits (A, B or C). This service message must be prevented
by carrying out a reset, to start the next service interval. To do this, pro­
ceed as follows:
1. Press the two menu
2. Press the
3. Press key
4. Press the
5. Using the
6. Confirm by pressing the
7. Press the
8. Press the
9. Press the
10. Press the
11. Confirm by pressing the
12. Press the
AD-0000082-01
For a service, always perform the following standard inspection and main­
tenance operations.
10.3.1
1. Check the water pressure.
2. If necessary: top up the central heating system.
Starting a new service interval
keys at the same time and then press the
key until the symbol flashes in the menu bar.
key.
The display alternates between
erating hours, for example
several times until
key.
The display shows
or keys, set the installer code
key several times until
with a flashing (for example). In this example, the next service
message is .
key again.
appears on the display.
key.
appears with a flashing
key to adjust the setting to
The new service interval begins.
key 3 times to leave this menu and return to the op­
eration display.
Warning
Always wear safety goggles and a dust mask during cleaning work
(involving compressed air).
Caution
Check whether all gaskets have been positioned properly (abso­
lutely flat in the appropriate groove means they are gas tight).
During the inspection and maintenance operations, water
(drops, splashes) must never come into contact with the electri­
cal parts.

Checking the water pressure

The water pressure must be at least 0.8 bar. If the water pressure
is too low, the symbol
Important
For open vented systems, the water pressure must be at
least 0.3 bar (Q30/Q45/Q65/Q90) or 0.5 bar (Q115).
10 Maintenance
and the number of boiler op­
.
flashes on the menu bar.
.
.
key.
appears on the display
.
.
key.
will appear.
63