Error Memory; Reading Out The Error Memory - REMEHA Quinta Pro 30 Installation, User And Service Manual

11.2

Error memory

Fig.68 Reading out an error
4x
2x
123157 - v.12 - 07022018
The boiler control unit has an error memory. It stores the last 16 errors that
have occurred.
In addition to the error codes, the following data is also saved:
Number of times that the error occurred: (
Boiler operating mode (
The flow temperature (
when the error occurred.
To view the error memory, you must first enter the access code
11.2.1

Reading out the error memory

1. Press the two
until the symbol flashes in the menu bar.
2. Select the installer menu using the
3. Use the
4. To confirm, press the
5. The error list or blocking list can be displayed by pressing the
key.
6. Confirm by pressing the
e.g.
7. Use the
8. Press the
9. Press the
sensor is connected (accessory)
10. Press the
11. Use the
AD-0000090-01
12. Press the
13. Press the key
).
) and the return temperature (
keys at the same time and then press the
appears on the display.
or keys to set the installer code
key.
appears on the display.
key.
appears with a flashing
.
or keys to scroll through the errors or blocks.
key to display the details of the errors or blocks.
or key to view the following data:
= Number of times that the error occurred.
= Number of operating hours.
= Status.
= Sub-status.
= Flow temperature (°C).
= Return temperature (°C).
= Calorifier temperature (°C).
= Outside temperature (°C). Only if an outside temperature
= Solar boiler temperature (°C).
= Internal set point (°C).
= Ionisation current (μA).
= Fan speed (rpm).
= Water pressure (bar).
= Supplied relative heat output (%).
key to interrupt the display cycle.
appears with a flashing
or keys to scroll through the errors or blocks.
key to show the error list or blocking list.
twice to exit the error menu.
11 Troubleshooting
).
key
key.
.
or
= last error that occurred,
= last error that occurred.
)
.
75