Headwall Nano-Hyperspec Operation Manual page 31

(a) If the computer doesn't find the GPS/IMU an error will show.
(b) Close the error message and wait a minute, then click Scan again.
(4) Select the input type, the Use Motion Tracker is selected.
(5) Click Next.
(6) The Log Directory Selection opens.
(7) Accept the default or select another location.
(a) To change location, click Change and navigate to the desired directory.
(8) When the directory is selected, click Start.
(9) Begin performing the calibration by rotating the sensor with attached GPS/IMU on its center point.
Figure 2-15. Magnetic Field Mapper Input Type.
Figure 2-16. Magnetic Mapper Directory Selection.
GPS/IMU MAPPING
2-27