Headwall Nano-Hyperspec Operation Manual page 16

AIRBORNE PACKAGE
b. Remove the LEMO-Data cable from the airborne package.
c. Hold the data serial connector and orient it so the holes in the cable-end connector match the pins in the Nano data
port connector.
d. Place the cable-end connector into place in the Nano data port connector and press down on connector edges until it is
completely secure.
The LEMO to Serial cable is sized to the customer's configuration. For this reason the
cable may be a different length than that shown in the above figure.
Figure 1-13. Cable Connector secured in Nano Connector Housing.
e. Hold the LEMO-Data cable, take the LEMO connector and align the red dot on the LEMO connector to the red dot on
the IMU connector, shown in Figure 1-14.
1-12
Figure 1-12. LEMO-Data Cable.
NOTE