Operate
6.2 Parameter description
"2.1.4.19 Density Unit"
Factory setting:
Adjustment range:
Purpose:
Description:
"2.1.4.20 Density"
Factory setting:
Adjustment range:
Purpose:
Description:
"2.1.5 Mass Flow"
Note
This menu command is visible only if "mass flow"" has been selected under "2.1.1 PV
Select" (Page 83).
See also
"Mass flow" measurement type (Page 151)
"2.1.5.1 Bidirectional Flow Activation"
Factory setting:
Adjustment range:
90
g/cm
3
g/cm
, kg/m
, lb/Gal, lb/ft
3
3
3
Selection of the unit for the density parameter
This parameter allows you to select the unit for the measured density value.
1 g/cm
3
Freely selectable numeric value
Setting the value for the density
This parameter allows you to set the value for the density of the medium,
which is used for conversion between volume and mass.
Adjust the settings for the measurement range when you change the values
for density!
Off
Off
•
On
•
, g/ml, kg/l, g/l, lb/in
, ug/l, ug/m
3
Operating Instructions, 12/2014, A5E02344528-09
3
SITRANS P500 with HART