2.4 Service - Siemens Sitrans P500 Operating Instructions Manual

Operate
6.2 Parameter description
6.2.3.4

"2.4 Service"

"2.4.1 Test/Reset
"2.4.1.1 Device Selftest"
Purpose:
Description:
"2.4.1.2 Displaytest"
Purpose:
Description:
"2.4.1.3 Master Reset"
Purpose:
Description:
"2.4.1.4 Config Changed Counter"
Purpose:
Description:
"2.4.1.5 Reset ConfigChangedCounter"
Purpose:
Description:
104
Device carries out a self-test
The function carries out a self-test. The result is shown in the "3.1 Alarm list"
(Page 123) menu.
Device performs a display test
This function performs a display test.
HART can also assist you to uniquely identify a device.
Device restarts
The device restarts (cold start). This does not reset any parameters. After
the restart, a few seconds elapse before the device is again in normal oper-
ation.
Counts the changes in configuration
The parameter counts each change to the configuration of the pressure
transmitter. Each change to a parameter is a change in configuration and
this counter is incremented by one.
Resetting the configuration counter to zero
The function resets the configuration counter and the "configura-
tion_changed" bit to zero.
SITRANS P500 with HART
Operating Instructions, 12/2014, A5E02344528-09