Q. Install lifting arms and adjust the arm locks
1. Install lifting arms. (Fig. 40)
2. Lower the carriages down to the lowest position. Use an 8mm Allen wrench to
loosen the bolt. (Fig. 41)
Fig. 40
3. Adjust arm lock in direction of arrow. (Fig. 42)
4. Adjust moon gear and arm lock until they mesh, then tighten the Allen bolts
on the arm lock. (Fig. 43)
Arm Lock
Installation Steps
Use the 8mm
Allen Head
Wrench to
loosen the
Snap Ring
Moon Gear
Fig. 42
PV-10PX / PV-10HPX
Allen Bolt
Fig. 43
Fig. 41
Tighten the
bolts after
the moon
gear and
arm lock
mesh well
35