Menu Structure - Siemens SITRANS F M MAG 5000 Operating Instructions Manual

Lock field symbols
Keypad
The keypad is used to set the flowmeter. The keys function as follows:
TOP UP KEY
FORWARD KEY
BACKWARD KEY
CHANGE KEY
SELECT KEY
LOCK/UNLOCK
KEY
6.3

Menu structure

The menu is built up of two parts. An operator menu and a setup menu, see also overview
diagrams MAG 5000/6000 (Page 73) and MAG 5000/6000 CT (Page 75).
Operator menu
The operator menu is for daily operation. It is customized in the operator menu setup. The
transmitter always starts up in operator menu No. 1. The forward
Setup menu
The setup menu is for commissioning and service only. Access to the setup menu is gained
by pressing the top up key
● View mode
● Setup mode
View mode is a read-only mode. The pre-selected settings can only be scanned.
Setup mode is a read and write mode. The pre-selected settings can be scanned and
changed. Access to the setup mode is password-protected. The factory set password is
1000.
SITRANS F M MAG 5000/6000
Operating Instructions, 01/2010, SFIDK.PS.026.G1.02
Ready for change
Value locked
are used to step through the operator menus.
Access to submenu
RESET MODE: Zero setting of totalizers and
initialization of setting
This key (when held for 2 sec.) is used to switch between
operator menu and setup menu. In transmitter setup menu,
a short press will cause a return to previous level.
This key is used to step forward through the menus. It is the
only key normally used by the operator.
This key is used to step backwards through the menus.
With this key settings or numerical values are changed.
With this key figures to be changed are selected.
This key enables the operator to change settings and it
gives access to submenus.
for 2 seconds. The setup menu operates in two modes:
Commissioning
6.3 Menu structure
and the backward keys
39