Siemens SITRANS F M MAG 5000 Operating Instructions Manual page 43

Parameter
Empty pipe cut-off
Error level
Note
Totalizer 2 is not visible when batch is selected as digital output.
Note
Q
max
Change basic settings as follows:
1. Press top up key
2. Enter password.
3. Use forward key
4. Press lock/unlock key
5. Use forward key
6. Press lock/unlock key
7. Use select key
8. Press lock/unlock key
9. Repeat steps 5-8 to change other settings.
10. Press top up key
See change basic settings menu diagram (Page 77).
Decimal point can be positioned and units set individually for flow rate in totalizer 1 and
totalizer 2.
Changing decimal point position
1. Enter the respective totalizer menu.
2. Use select key
3. Use change key
Changing units
1. Use select key
2. Press change key
SITRANS F M MAG 5000/6000
Operating Instructions, 01/2010, SFIDK.PS.026.G1.02
Description
When set to "On" the alarm will indicate when sensor is running empty. All
readings, display and outputs, will indicate zero.
Selecting error level at which flowmeter will detect an error.
2 is visible only when chosen as external input.
for 2 sec.
to reach basic settings menu.
or backward key
and change key
two times to exit setup mode.
to position cursor below decimal point.
to move decimal point to requested position.
to position cursor below unit.
until requested unit is displayed.
to unlock settings.
to reach relevant menu.
to unlock settings.
to change settings.
to confirm new settings.
Commissioning
6.5 Changing basic settings
41