General Safety Regulations - Fimap Mx Series Use And Maintenance Manual

Table of Contents

Advertisement

The regulations illustrated below must be carefully followed in order to avoid harm to the operator and damage to the machine.
Read the labels on the machine carefully. Do not cover them for any reason and replace them immediately if they become damaged.
The machine must be exclusively used by authorised, trained personnel.
During the working of the machine, pay attention to other people and especially to children.
The machine is not suitable for cleaning carpets.
The socket for the battery charger cable must have a prescribed earth connection.
Avoid damaging the battery charger cable by crushing or bending it, or by applying stress.
If you notice any damage to the battery charger cable, contact a FIMAP technical assistance centre immediately.
Do not mix different types of detergent as this may produce harmful gases.
Do not place any liquid containers on the machine.
The machine is designed for dry use only and should not be used or kept outdoors in wet conditions.
The storage temperature must be between -25°C and +55°C; do not store outdoors in damp conditions.
Conditions of use: room temperature between 0°C and 40°C with relative humidity between 30 and 95%.
Do not use the machine in an explosive atmosphere.
Do not use the machine as a means of transport.
Do not use acid solutions which may damage the machine.
Avoid working with the brushes when the machine is standing still, so as not to damage the floor.
Do not vacuum inflammable liquids.
Do not use the device to collect dangerous powders.
In the event of a fire, use a powder extinguisher. Do not use water.
Do not knock against shelving or scaffolding, where there is a danger of falling objects.
If the machine is used where there is a risk of falling objects, the machine must be equipped with protection devices against falling objects.
Do not use the machine on surfaces with an inclination greater than the one shown on the plate.
The machine is designed to simultaneously carry out the washing and drying operations. Different operations should only be carried out in areas
where the passage of unauthorised persons is prohibited. Signal the presence of damp floors with suitable signs.
If the machine does not work properly, verify that this is not caused by failure to carry out routine maintenance. Otherwise, request the intervention of
the FIMAP technical assistance centre.
If you need to replace any components, request the ORIGINAL spare parts from a FIMAP dealer and/or Authorised Retailer.
Before carrying out any maintenance work, switch off the machine and disconnect the battery connector.
Do not remove any protection devices which require the use of tools in order to be removed.
Do not wash the machine with direct water jets or with pressurised water, nor with corrosive substances.
Send the machine to a FIMAP technical assistance centre for servicing at least once a year.
To prevent scaling in the solution tank filter, do not fill the tank with detergent solution many hours before using the machine.
Before using the machine, verify that all the hatches and covers are positioned as shown in this Use and Maintenance Manual.
When disposing of consumption materials, comply with currently effective laws and regulations.
When your FIMAP machine has reached the end of its long working life, dispose of the materials it contains in an appropriate manner, and bearing in
mind that the machine itself was constructed using 100% recyclable materials.
Only use the brushes supplied with the device, or those specified in the Use and Maintenance Manual (page 37). The use of other brushes could
compromise safety levels.
The device must be disconnected from the power supply before removing the battery.
The battery must be removed from the device before this is disposed of.
The battery and battery charger must be disposed of in a safe manner by scrupulously comply with currently effective laws.
The machine is not suitable for use by children or people with reduced physical, mental and sensorial capacities, or people lacking experience and
knowledge, unless supervised and instructed in the use of the machine by a person responsible for their safety.
Children must be supervised to ensure they do not play with the device.
To prevent unauthorised use, remove the key after use.
When the machine if left unattended, engage the parking brake for safety against unintentional movements.

GENERAL SAFETY REGULATIONS

8

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mx Series and is the answer not in the manual?

Questions and answers

Table of Contents