Brush Assembly (Brush Head With Single Disc Brush) - Fimap Mx Series Use And Maintenance Manual

Hide thumbs

Table Of Contents

Table of Contents

Fill the tank (1) in the internal compartment behind the battery with liquid detergent according to the

directions on the label. Be sure to close the screw cap correctly, to avoid any liquid leaking out during

normal machine usage.

WARNING: always use low foam detergent. To avoid the production of foam,

before starting to clean, put a minimum quantity of antifoam liquid into the

recovery tank. Do not use pure acids.

ATTENTION: The FSS automatic dosing system is designed to work with any liquid detergent. For this

reason, the percentage of detergent in the solution is subject to a maximum error of 5% compared with the

nominal value selected.

ATTENTION: the metering system is particularly suitable for frequent

maintenance cleaning.

Acid or alkaline detergents can be used with pH values between 4 and 10 and

that do not contain: oxidising agents, chlorine or bromine, formaldehyde,

mineral solvents.

The detergents used must be suitable for use with scrubbing machines.

If the system is not use on a daily basis, wash the circuit with water after use.

The system can be excluded. In the case of occasional use of detergents with a

pH of 1-3 or 11-14, use the scrubbing machine in the traditional way by adding

the detergent in the water clean tank and excluding the metering circuit.

ATTENTION: always use detergents whose manufacturer's label indicates

their suitability for scrubbing machines. Do not use acid or alkaline products or

solvents without this indication.

In addition, you are advised to always use low foam detergents.

Do not use pure acids or detergents with a stronger gradation than that

indicated on the label supplied.

ATTENTION: Protective gloves should always be worn before handling

detergents or acidic or alkaline solutions to avoid serious injury to hands.

23.