DSC TL280 Installation Manual page 21

[991] Firmware Version
This section will display the current firmware version of the device. Update worksheets with new version after a flash update is
completed.
[992] Ethernet IP Address
This section will display the IP address of the Ethernet connection. This value is programmed in section [001] or assigned by
DHCP.
[993] Ethernet Gateway Address
This section will display the IP address of the Ethernet gateway. This value is programmed in section [003] or assigned by
DHCP.
[998] MAC Address
This section will display the unique12-digit, hexadecimal number assigned as the Media Access Control (MAC) address of the
device.
System Reset Defaults
[999] Software Default
Default (99);
The software default allows the installer to refresh the unit after changes and also return the communicator to the default state.
00: Default Module. All programming sections in module revert to factory settings. This will erase all existing programming of
the unit.
55: Reset. The communicator is reset. This option is equivalent to power cycling the communicator.
21