Table of Contents
Advertisement
Bonnet
Open the Bonnet
DO NOT drive when the bonnet is not closed
or retained only by the safety catch.
256
Maintenance
1 Pull the bonnet release handle (A) from the inside
of the car.
2 Push the lever (B) mounted on the bonnet to release
the bonnet safety catch.
3 Raise the bonnet and hold it up with the support rod
firmly.
Closing the Bonnet
Support the bonnet by one hand, release the support rod
by the other hand, and place it firmly into the support rod
base. Then hold the bonnet by both hands and lower it,
allowing it to drop for the last 20cm～30cm to fully close
the bonnet.
By attempting to lift the front edge of the bonnet, check if
the lock is fully engaged after closing the bonnet. If it is not
fully engaged, you must repeat the operation.
Bonnet Unlock Alarm
If the bonnet is not fully engaged, when the ignition switch
is in ON/RUN/START position, the corresponding alarm
icon (refer to "Information Center" in "Instruments and
Controls" chapter) will be displayed in the information
Advertisement
Table of Contents
