MG GS Handbook page 259

Check or Replace a Fuse
1 Turn off the ignition switch and all electrical
appliances, and disconnect the battery negative cable.
2 Press the lock catch to open the upper cover of
engine compartment fuse box.
3 Hold the fuse head with the fuse extraction tool, pull
and remove the fuse, and check if the fuse is blown.
4 If a fuse is blown, replace it with another fuse of the
same ampere value.
Fuse Specification
Code Specs
F1 10A Engine control module
F2 15A Engine control module
Upstream oxygen sensor, downstream
oxygen sensor, electronic thermostat
F3 20A (1.5T), VVT Valve - Intake (1.5T), VVT
Valve - Exhaust (1.5T), master cylinder
stroke sensor (6MT）
Emergency Information
Function
Code Specs
Air flow meter (1.5T), ignition
F4 15A
coil1,2,3,4
Canister control valve, VVT valve
- intake（2.0T）, VVT valve -
exhaust(2.0T), exhaust gas control
valve, clutch water pump（2.0T）,
F5 10A
electronic thermostat（2.0T）, air
flow meter(2.0T), Dump valve, brake
lamp signal sensor， neutral position
sensor(6MT)
Exterior rearview mirror heating
F6 7.5A
element
F7 10A Electronic water pump relay
F8 15A Fuel pump relay
F9 15A Transmission control module (6TST)
Driver window regulator motor
F10 30A
F11 5A Airbag control module
Function
245
5