HEIL DuraPack 5000 2017 Operation Manual page 99

CHECKS AND INSPECTIONS
Inspect level of hydraulic oil if tank is mounted on street side. It must be full. Add recommended oil as
necessary.
Battery disconnect switch is turned to OFF then:
Check wiring and battery cables from the battery box to the engine starter for wear and other damage.
IMMEDIATELY REPLACE WORN OR DAMAGED WIRING
Check wiring and cables for loose connections. IMMEDIATELY TIGHTEN LOOSE CONNECTIONS
OPERATION OF UNIT
Make sure the air tank drain valve is closed.
Turn battery disconnect to ON.
Apply parking brake.
Make sure the starter interlock operates – make sure unit will not start in gear.
Start the engine.
Indicator lights and gauges show normal operation of engine.
Make sure the parking brake does not allow the vehicle to move forward or reverse at idle.
Make sure the throttle advance (if equipped) operates only in neutral.
Check all cab, body and tailgate lights for proper operation.
Make sure the backup alarm and light operate.
Make sure all people not necessary and any hazards are clear of the area and then:
Operate the in-cab controls and make sure:
Issued September 2017
Daily Checklist
DuraPack
- Skip this section if the unit will not be operated today
®
5000
INSPECTION
RESULTS CODE
Copyright 2017, Heil Environmental
Printed in U.S.A.
91