LEAVING THE ROUTE FOR THE LANDFILL/
TRANSFER STATION
At the end of the route, or when the unit has a full load,
prepare the unit to go to the landfill. See Driving to Pick-
up Locations
and make sure the unit is properly set up
109
for travel.
The tailgate is fully LOWERED and CLOSED. Check
the TAILGATE UP light in the cab. It must be OFF.
The tailgate clamps (turnbuckles) are tight and
secure the tailgate.
If equipped with a winch or reeving mechanism, the
cable hook is secured in the eye on the tailgate.
The left and right hand access doors are both closed
and secured. For each door:
o The quick release pin is secured in the barrel.
o The wing screw is securely tightened against the
door.
For a unit with refuse, the blade is up tight against
refuse. For a unit with no refuse, the blade is at the
START POSITION.
The ejector panel is at the front of the body.
If equipped, the PTO is DISENGAGED.
The PUMP ON switch is OFF.
You properly ADJUST and CLEAN the mirrors.
All outside lights turn ON and OFF.
If equipped, the side access door is CLOSED and
LOCKED.
Issued September 2017
On-Route Operation Procedures
®
DuraPack
5000
NOTES:
136
Copyright 2017, Heil Environmental
Printed in U.S.A.