Check The Traveling Or "In-Transit" Position - HEIL DuraPack 5000 2017 Operation Manual

CHECK THE TRAVELING OR "IN-TRANSIT"
POSITION
When you travel to and from the landfill or transfer station,
make sure the unit is in the in-transit mode as follows (see
the figure to the right):
The tailgate is fully LOWERED and CLOSED. Check
the TAILGATE UP light in the cab. It must be OFF.
The tailgate clamps (turnbuckles) are tight and
secure the tailgate.
If equipped with a winch or reeving mechanism, the
cable hook is secured in the eye on the tailgate.
The left and right hand access doors are both closed
and secured. For each door:
o The quick release pin is secured in the barrel.
o The wing screw is securely tightened against the
door.
For a unit with refuse, the blade is up tight against
refuse. For a unit with no refuse, the blade is at the
START POSITION.
The ejector panel is at the front of the body.
If equipped, the PTO is DISENGAGED.
The PUMP ON switch is OFF.
You properly ADJUST and CLEAN the mirrors.
All outside lights turn ON and OFF.
If equipped, the side access door is CLOSED and
LOCKED.
Issued September 2017
Before Going on Route
®
DuraPack 5000
Figure 55. In-Transit Position
Copyright 2017, Heil Environmental
104
Printed in U.S.A.