Loading Refuse With A Cart Tipper - HEIL DuraPack 5000 2017 Operation Manual

LOADING REFUSE WITH A CART TIPPER

A cart tipper is a Rear End Loader (REL) option attached to
the tailgate that allows an operator to secure a residential
refuse container and unload its contents into the hopper
Use the instruction that follow to load refuse from a
commercial refuse container into the hopper with a cart
tipper. See the figure to the right for the location of the cart
tipper control lever.
Observe the DANGER and WARNING notices.
DANGER
Your body or clothing can become caught by the blade
while it moves. Serious injury or death may occur if a
person is in or near the hopper when the blade and upper
panel move. Clear the area near the hopper of all
unnecessary people before you move the blade and upper
panel and keep all parts of your body away from the blade.
1. Move the upper panel and blade into the START
position. See Figure 43
a. PUSH the upper panel and blade levers at the
same time and RELEASE the levers. The levers
will self-center at the end of the commanded
position by way of valve internal hydraulic
pressure.
b. The upper panel will move IN and the blade will
move DOWN.
c. The hopper is now ready to receive refuse.
Issued September 2017
On-Route Operation Procedures
DuraPack
.
110
®
5000
Figure 69. Cart Tipper Control Lever
2. Load the refuse from a container into the hopper.
See Figure 44
111
container in front of the cart tipper until the container
latch bar is over the cart tipper saddle.
CAUTION
A refuse container that is not in good condition may not be
secured by the cart tipper's latch and can suddenly move.
Minor or moderate injury can occur when a person is
struck by a moving container that is not properly secured.
Make sure the refuse container is properly secured to the
cart tipper before you raise or lower the container.
and Figure 45 . Set the refuse
111
Copyright 2017, Heil Environmental
Printed in U.S.A.
130