Loading Refuse With A Winch (Continued) - HEIL DuraPack 5000 2017 Operation Manual

LOADING REFUSE WITH A WINCH
(CONTINUED)
e. After the refuse container is empty of refuse,
PUSH the control lever for the winch until the
refuse bin rests firmly on the ground and there is
enough slack in the cable to remove the cable
hook from the refuse container.
f. Remove the cable hook and attach it to the eye
on the tailgate.
g. PULL the control lever for the winch mechanism
until the cable tightens and secures the hook in
the eye on the tailgate.
h. RELEASE the container's trunnion bar from the
latch bar. See Using a Latch Bar
i. MOVE the container to its pick-up location.
j. Sweep the refuse from the hopper and pack it into
the body.
3. Sweep the refuse from the hopper and pack it into
the body.
a. PULL the upper panel and blade levers at the
same time and RELEASE the levers. The levers
will self-center at the end of the commanded
position by way of valve internal hydraulic
pressure. See Figure 44
Issued September 2017
On-Route Operation Procedures
DuraPack
.
133
.
111
®
5000
b. The upper panel will move OUT and the blade will
move UP. STOP the blade UP operation when the
blade is at the pinch point with the hopper sill.
c. Watch for refuse that is pushed out of the hopper.
d. PUSH the upper panel and blade levers at the
same time and RELEASE the levers. The levers
will self-center at the end of the commanded
position by way of valve internal hydraulic
pressure. See Loading Refuse Manually
(Continued) .
111
4. The upper panel and blade move and compact the
refuse into the body.
5. Repeat Steps 1 and 3 as necessary to compact the
refuse.
6. Leave the blade against the refuse.
120
Copyright 2017, Heil Environmental
Printed in U.S.A.