Loading Refuse With A Winch (Continued) - HEIL DuraPack 5000 2017 Operation Manual

LOADING REFUSE WITH A WINCH
(CONTINUED)
1. Move the upper panel and blade into the START
POSITION. See Figure 43
a. PUSH the upper panel and blade levers at the
same time and RELEASE the levers. The levers
will self-center at the end of the commanded
position by way of valve internal hydraulic
pressure.
b. The upper panel will move IN and the blade will
move DOWN.
c. The hopper is now ready to receive refuse.
2. Load the refuse from a container into the hopper.
See See Figure 44
a. Remove the winch's cable hook from the eye on
the tailgate.
b. PUSH the control lever for the winch until you
have sufficient cable to connect to the refuse bin.
Issued September 2017
On-Route Operation Procedures
DuraPack
.
110
and Figure 45 .
111 111
®
5000
WARNING
A refuse container that is not in good condition with
retaining washers in place may not be secured with the
latch bar and can suddenly move. Death or serious injury
can occur when a person is struck by a moving container
that is not properly secured. Make sure the refuse
container is properly secured to the latch bar before you
raise or lower the container.
c. Make sure the latch bar secures the container
BEFORE you raise the container. See Using a
Latch Bar .
133
d. PULL the control lever for the winch until the
refuse container lifts over the hopper sill and the
refuse empties into the hopper. RELEASE the
control lever. If necessary, you can PRESS the
Throttle Advance Switch during loading.
When the refuse container's cover is not closed
because it is overfilled with refuse:
(1) Raise the container enough to empty part of
the refuse from container into the hopper
(2) Lower the container to the ground
(3) Perform Step 3
compact it into the hopper)
(4) Raise the container and finish emptying the
container.
(sweep the refuse and
120
Copyright 2017, Heil Environmental
Printed in U.S.A.
119