CHECKS AND INSPECTIONS
Winch
Arm Mechanism
Roll Bar
Issued September 2017
Daily Checklist
DuraPack
Release the cable hook from it storage eye and hold the hook
PUSH the control lever – the cylinder should OUT (EXTEND)
PULL the control lever – the cylinder should move IN (RETRACT)
Attach the cable hook to its storage eye
Release the cable hook from it storage eye and hold the hook
PUSH the control lever – the winch spool should UNWIND the cable from the spool
PULL the control lever – the winch spool should WIND the cable on the spool
Attach the cable hook to its storage eye
PULL the control lever – the lift arms should RAISE
PUSH the control lever – the lift arm should LOWER
Make sure the arm mechanism is at the full LOWER position
PULL the control lever – the roll bar should RAISE
PUSH the control lever – the roll bar should LOWER
Make sure the roll bar is at the full LOWER position
®
5000
INSPECTION
RESULTS CODE
Copyright 2017, Heil Environmental
Printed in U.S.A.
93