Standard Outside Controls - HEIL DuraPack 5000 2017 Operation Manual

STANDARD OUTSIDE CONTROLS

The standard outside controls for the unit are located on
the front street side of the body and on the curb side of the
tailgate near the hopper.
The upper panel and packer blade levers have detents.
Once you push or pull the lever past the detent (fully push
or pull the lever), the selected operation continues and you
can release the lever. The lever will self-center at the end
of the commanded operation by way of internal hydraulic
pressure. You can reverse the direction of a function at any
time when you push or pull the lever past the detent in the
opposite direction.
You must move the tailgate and ejector levers in the
direction of travel you want and hold the lever at that
position until the tailgate or ejector reaches the desired
position then release the lever. You can stop an operation
at any time by releasing the lever.
DANGER
Your body or clothing can become caught by the blade
while it moves. Serious injury or death may occur if a
person is in or near the hopper when the blade and upper
panel move. Clear the area near the hopper of all
unnecessary people before you move the blade and upper
panel and keep all parts of your body away from the blade.
A. PACKER BLADE Lever
This lever is on the curb side of the tailgate next to the
UPPER PANEL lever. It is the lever closest to the end of
the tailgate. See the figures on the next two pages.
Issued September 2017
Controls, Switches, and Indicator Lights
®
DuraPack 5000
1. PUSH the lever to the FULL DOWN position and
RELEASE it to MOVE the blade UP.
2. PULL the lever to the FULL UP position and
RELEASE it to MOVE the blade DOWN.
3. MOVE the lever in the opposite direction to stop an
UP or DOWN operation at any time.
4. You usually operate this lever at the same time you
operate the UPPER PANEL lever to:
a. OPEN the hopper to load refuse
b. CLOSE the hopper for the in-transit position
c. MOVE and COMPACT the refuse in the hopper to
B. UPPER PANEL Lever
This lever is on the curb side of the tailgate next to the
BLADE lever. See the figures on the next two pages.
1. PULL the lever to the UP position and RELEASE it to
MOVE the upper panel IN.
2. PUSH the lever to the DOWN position and
RELEASE it to MOVE the upper panel OUT.
3. MOVE the lever in the opposite direction to stop an
IN or OUT operation at any time.
4. You usually operate this lever at the same time you
operate the BLADE lever to:
a. OPEN the hopper to load refuse
b. CLOSE the hopper for the in-transit position
c. MOVE and COMPACT the refuse in the hopper to
the body.
the body.
Copyright 2017, Heil Environmental
66
Printed in U.S.A.