HEIL DuraPack 5000 2017 Operation Manual page 133

LOADING REFUSE WITH AN ARM
MECHANISM (CONTINUED)
c. Watch for refuse that is pushed out of the hopper.
d. PUSH the upper panel and blade levers at the
same time and RELEASE the levers. The levers
will self-center at the end of the commanded
position by way of valve internal hydraulic
pressure. See Figure 45
e. The upper panel and blade move and compact
the refuse into the body.
4. Repeat Steps 1 and 3 as necessary to compact the
refuse.
5. Leave the blade against the refuse.
DANGER
Do not use riding step when vehicle speed is more than 10
MPH or to travel more than 2 tenths (0.2) of a mile. Do not
use riding step when vehicle operates in reverse. Always
face vehicle when using riding step.
DANGER
Do not use an arm mechanism or roll bar as a riding step.
Obey safety messages and use the riding step for when
traveling on the unit. Serious injury or death may occur.
Issued September 2017
On-Route Operation Procedures
DuraPack
.
111
®
5000
DANGER
Do not ride on or in the hopper opening. Use riding step
and obey all safety messages.
6. Each helper must PRESS the buzzer on their side of
the tailgate and let the driver know each helper is
ready to move to the next location.
7. Go to the next stop on the route.
125
Copyright 2017, Heil Environmental
Printed in U.S.A.