Loading Refuse With A Winch - HEIL DuraPack 5000 2017 Operation Manual

LOADING REFUSE WITH A WINCH

An option for Rear End Loaders (RELs), a winch is a
mechanism with a hook and cable that an operator uses to
raise, dump and lower a commercial refuse container
The winch hook and cable are not intended for any other
purpose than dumping a Type T container into the hopper.
The hook and cable should not be used for lifting, dragging,
or manipulating containers, appliances, or other large items
toward or into the hopper.
Use the instructions that follow to load refuse from a
commercial refuse container into the hopper with a winch.
Observe the DANGER and WARNING notices.
DANGER
Your body or clothing can become caught by the blade
while it moves. Serious injury or death may occur if a
person is in or near the hopper when the blade and upper
panel move. Clear the area near the hopper of all
unnecessary people before you move the blade and upper
panel and keep all parts of your body away from the blade.
Issued September 2017
On-Route Operation Procedures
®
DuraPack 5000
WARNING
Crush or Pinch Hazard.
Lifting or dragging uncontrolled items with hook and cable
may cause items to move in a way that can pinch or crush
the operator.
Use winch or reeving cylinder hook and cable for dumping
properly restrained ANSI Type T containers only.
Never use hook and cable for any other purpose.
Failure to comply may injure or kill.
CAUTION
The upper panel in/out and blade up/down operations can
push refuse out of the hopper or break objects. Refuse
broken by the blade can cause moderate or minor injury.
Stay clear of the packer panel during upper panel in/out
and blade up/down operations.
118
Copyright 2017, Heil Environmental
Printed in U.S.A.