Optional Outside Controls (Continued) - HEIL DuraPack 5000 2017 Operation Manual

OPTIONAL OUTSIDE CONTROLS
(CONTINUED)
DANGER
Container lifting equipment in motion is dangerous.
Serious injury or death may occur if a person is struck by a
refuse container or the lifting equipment. Clear the area
near the tailgate of all unnecessary people before you use
the container lifting equipment.
WARNING
A refuse container that is not in good condition with
retaining washers in place may not be secured with the
latch bar and can suddenly move. Death or serious injury
can occur when a person is struck by a moving container
that is not properly secured. Make sure the refuse
container is properly secured to the latch bar before you
raise or lower the container.
A. REEVING MECHANISM
An optional reeving mechanism (a cylinder with an
attached cable and hook) will be located along the
center line of the roof with its hook end at the top of the
tailgate. When not in use, you secure its hook in the eye
provided on either side of the tailgate. You use the
reeving mechanism and its hook to secure a commercial
refuse bin, pull it to the hopper, tip the bin to empty the
refuse into the hopper and lower the bin to the ground.
1. PUSH the lever to the LOWER position and HOLD it
there to MOVE the cylinder OUT (EXTEND).
Issued September 2017
Controls, Switches, and Indicator Lights
®
DuraPack 5000
2. PULL the lever to the RAISE position and HOLD it
there to MOVE the cylinder IN (RETRACT).
3. RELEASE the lever to stop a RAISE or LOWER
operation at any time or when the cable hook is at
the position you want.
4. Attach the latch bar to the refuse bin BEFORE you
attach the hook to the refuse container.
5. PULL/PUSH the lever to RAISE the container over
the hopper lip, dump the refuse from the container
and lower the container to the ground.
B. WINCH
An optional winch will be mounted at the top, center of
the tailgate. You use the winch and its hook to secure a
commercial refuse bin, pull it to the hopper, tip the bin to
empty the refuse into the hopper and lower the bin to the
ground. The lever controls the RAISE and LOWER
operations of the winch.
1. PUSH the lever to the LOWER position and HOLD it
there to UNWIND the cable.
2. PULL the lever to the RAISE position and HOLD it
there to the WIND the cable.
3. RELEASE the lever to stop an LOWER or RAISE
operation at any time or when the cable hook is at
the position you want.
4. Attach the latch bar to the refuse bin BEFORE you
attach the hook to the refuse container.
5. PULL/PUSH the lever to RAISE the container over
the hopper lip, dump the refuse from the container
and lower the container to the ground.
Copyright 2017, Heil Environmental
Printed in U.S.A.
74