Step 5-Connect Lan And/Or Serial Equipment - Microwave Data Systems MDS entraNET 900 System Manual

Item
Subnet Mask
Net Address
RF Output
Power
Unit Password
MDS 05-4055A01, Rev. A
Table 3-2. Basic Configuration Defaults (Remote) (Continued)
Mgt. System Location
Main Menu>
Radio Configuration>
RF Power Output
Main Menu>
Device Information>
User Password
3.6 STEP 5—CONNECT LAN AND/OR
SERIAL EQUIPMENT
Connect a local area network to the
(DCE) or
COM1 COM2
capable of supporting your devices.
Models and Data Interface Services, on page 5
capabilities.) The
LAN
ment. This includes devices that use the Internet Protocol (IP).
NOTE: The
COM1
Management System. If you use the
services, you may find it convenient to use the
access to the entraNET Management System.
Figure 3-3 shows the default functions and services for the interface
connectors.
LAN
10BaseT
IP/Ethernet Port
IP Address: 192.168.1.1
COM1
DCE Console/Terminal
19,200 bps/8N1
No Handshaking
RS/EIA-232
Figure 3-3. Transceiver (AP) Interface Default Configuration &
MDS entraNET 900 System Guide (Preliminary)
Default
+30 dBm (1.0 Watt)
admin
(lower case)
port or serial devices to the
LAN
(DTE) ports. Make sure your transceivers are
(See Table 1-1 . MDS entraNET 900
port will support any Ethernet-compatible equip-
port also provides access to the transceiver's
Invisible place holder
COM2
DCE Serial Data Equip.
9,600 bps/8N1 PRIMARY POWER
Full Handshaking
RS/EIA-232.
Functions
Values/Range
20–30 dBm @ 50Ω
(0.1–1.0 Watts)
• 1–8 alphanumeric
characters
• Case-sensitive;
can be mixed case
for a summary of model
port for normal data
COM1
port for
LAN
ANTENNA
50Ω TNC
+30 dBm/1W Out (Max.)
–30 dBm Input (Max.)
13.8 Vdc @ 500 ma
(10.5–30 Vdc)
Negative Ground
+ Left – Right
81