Microwave Data Systems MDS entraNET 900 System Manual page 46

38 MDS entraNET 900 System Guide (Preliminary)
192.168.0.10
EIA-232
Terminal
or Computer
Figure 2-17. Point-to-Point Serial-to-Serial Application Diagram
Table 2-2. Serial Port Application Configuration
MDS entraNET 900
Unit Location
1
Access Point (COM2)
1
Remote Unit (COM2)
1. Either COM port can be used, but they must be the same ones at both ends
of the link. Both COM ports can be used simultaneously for two independent
data channels.
Invisible place holder
192.168.0.1
iNET 900
Access Point
Menu Item Setting
Status Enabled
Data Baud Rate 9,600 (Example)
Flow Control Hardware (Example)
Seamless Mode Disabled
Delimiter (Chars) 0
Buffer Size 0
IP Protocol UDP
Send to Address 192.168.0.2
(IP address of the entraNET
Remote)
Send to Port 30011
Receive on Port 30011 (Not used)
Receive on 0.0.0.0 (Not used)
Address
Status Enabled
Data Baud Rate 9,600 (Example)
Flow Control X-ON/X-OFF (Example)
Seamless Mode Disabled
Delimiter 0 (Characters)
Buffer Size 0 (Characters)
IP Protocol UDP
Send to Address 192.168.0.1
(IP address of the entraNET AP)
Send to Port 30011
Receive on Port 30011 (Not used)
Receive on 0.0.0.0 (Not used)
Address
192.168.0.2
EIA-232
RTU
iNET 900
Remote
MDS 05-4055A01, Rev. A