Operation Instructions - Rosslare AY-V12B Installation Manual

Operation Instructions

5. Operation Instructions
The reader should be tested after wiring it to a power supply and the
controller.
To test the reader:
1. Power up the reader. The red LED lights turn on. The beeper
sounds once.
2. Present the appropriate type of proximity card to the reader. The
LED momentarily flashes green and a short beep is emitted, thus
indicating that the card was read properly by the reader.
The reader transmits the card's data to the controller. The
controller checks the data and if it is valid, the LED changes
momentarily to green. It then returns to its idle state (red).
12 AY-V12B Installation Manual