As20Wrf/Brf Thermostat With Akl01/04/06Prf And Akl08Rf Wiring Centers - Salus SG888ZB System Manual

Section 4
AS20WRF/BRF Thermostat with AKL01/04/06PRF
and AKL08RF Wiring Centers
To begin pairing, all of the required components are to be powered: AS20WRF Thermostat, AKL
Wiring Center and AX10RF Receiver (if desired for boiler demand switching – RX1) . The LED ring
on the SG888ZB should be solid blue . The Network Status LED on the AKL Wiring Center should be
flashing and, if a AX10RF Receiver is used, the LED back light on the Auto/Manual switch should be
flashing red .
1 . Open the SALUS Smart Home mobile application and select the drop down
menu from the upper right side of the screen select:
Equipment All Equipment

The SG888ZB Gateway will begin flashing red while it is searching for the devices. This will
continue until the pair process is complete. The Network Status LED on the AKL Wiring Center
(red on the AKL01/04/06PRF and green on the AKL08RF) will flash. If an AX10RF Receiver is
used, the LED backlight on the Auto/Manual switch will be flashing red.
Device Pairing & Setup
with Internet Connection
Add New Equipment

Scan for Equipment

4 .5