Salus SG888ZB System Manual page 71

Section 8
Error Code
19
AX10RF (RX1) Receiver lost link
20
with Wiring Center
AX10RF (RX1) Receiver lost link
21
with Wiring Center
22 ARV10RFM Actuator – Low Battery*
23 Invalid Wireless Valve Actuator
24 Thermostat is rejected by Wiring Center
25 Thermostat lost link with parent
26–29
30 ARV10RM Actuator mechanical failure
31 ARV10RM Actuator adaptation failure
32
33 AX10RF Receiver lost link with devices
* These error codes will appear on all connected thermostats
Troubleshooting
Description
Not Used
Not Applicable
Reserved
Call Technical Helpline (855) 557-2587
Check to be sure that the wiring center is powered, and the network status light is on .
- If the network status light is flashing, perform the
pairing procedure listed in section 4 .
- Check that the AS20WRF/BRF Zone Thermostat is operating
and no other error codes appear .
- Replace Thermostat if necessary .
Replace the ARV10RFM Actuator Battery – This message will appear on all
connected thermostats .
The wireless valve actuator is either faulty or incompatible with the system .
The AS20WRF/BRF Thermostat installed was rejected by the AKL Wiring Center .
- Re-attempt the pairing procedure after cycling powerto the Wiring Center .
- Replace the AS20WRF/BRF Thermostat if necessary
The AS20WRF/BRF Thermostat installed was rejected by the AKL Wiring Center .
- Re-attempt the pair procedure after cycling power to the Wiring Center .
- Replace the AS20WRF/BRF Thermostat if necessary
Call Technical Helpline (855) 557-2587
Replace the ARV10RM Actuator
• Re-attempt the pairing procedure after resetting the Thermostat
• If problem persists, replace the ARV10RM Actuator
Call Technical Helpline (855) 557-2587
Re-attempt the pairing procedure after resetting the Receiver
Troubleshooting Steps
8 .2