Salus SG888ZB System Manual page 27

Section 4
2 . Select the check boxes for
both the Wiring Center
and the Zigbee Receiver
on the SALUS Smart Home
application . Then press
the orange "Connect
equipment" button .
5 . Once the Wiring Center is connected and the LED on the SG888ZB stops flashing, press the multi button
for two seconds . Zone LED on the AKL Wiring Center will illuminate indicating the ID number of the device .
Use this number when setting up the AS20WRF/BRF Thermostats to address the correct Wiring Center .
AKL Wiring Center ID Number Key
ID # Zone 1 Zone 2 Zone 3 Zone 4 Zone 5 Zone 6
1
2
3
4
5
6
7
8
9
0
Device Pairing & Setup
with Internet Connection
3 . Give each device a
descriptive name that allows
easy identification . If there
are multiple wiring centers,
identify each with respect to
its location or purpose .
4 . Press "Finish" and the
flashing red LED lights on
both devices should stay
solid red . This indicates they
are connected to the system .
6 . Press confirm
Thermostat to advance from the
The AS20WRF/BRF Thermostat goes through
it's boot sequence .
7 . Again, from the SALUS Smart Home mobile
application and select the drop down menu
from the upper right side of the screen select
Equipment All Equipment

Equipment Scan for Equipment

on the AS20WRF/BRF
Screen .
Add New

4 .6