As20Wrf/Brf Thermostat Configuration - Salus SG888ZB System Manual

Section 4

AS20WRF/BRF Thermostat Configuration

Prior to pairing, the AS20WRF/BRF Thermostat should be set to the desired configuration. The
default configuration for the thermostat is programmable (Pr o9) but it can also be configured as
non-programmable (nP r9). Note that earlier firmware may display (dI 9t) for the non-programmable
configuration. The non-programmable option is used for thermostats intended to be a member of a
thermostat group, part of an internet connected system, or a system where a schedule is not desired.
1 . Use
programmable) thermostat configurations . (Note: Skip the uu tr selection as this is not
applicable)
2 . Press
Once the AS20WRF Thermostat is properly configured, pairing with other devices may proceed .
Note: The uu tr configuration is not used and should not be selected. The AS20WRF/BRF
Thermostat configuration cannot be changed after pairing is completed without resetting it to
factory defaults and starting over. DO NOT PROCEED with pairing until the thermostat is in the
desired configuration. If the wrong configuration is chosen prior to pairing, press & hold the
, &
Device Pairing & Setup
with Internet Connection
or keys to select between Pr o9 (programmable) and nP r9 (non-
to confirm selection .
buttons to re-enter the Pr o9 mode.
4 .3