As20Wrf/Brf Thermostat - Installer Parameter Setup - Salus SG888ZB System Manual

Section 7
AS20WRF/BRF Thermostat – Installer Parameter Setup
Installers can set up the AS20WRF/BRF parameters using the SALUS Smart Home application if an SG888ZB
Gateway is used and connected to the internet. Alternatively, the parameters can be entered directly on
the AS20WRF/BRF Thermostat. The following procedure illustrates the offline setup. Changes made on the
application or on the thermostat may take a few minutes to go into effect.
Before starting set up procedures, press any key to light the display and prepare the Thermostat for input.
PM
1 2 3 4 5 6 7
1 . To set up installation
parameters on the
AS20WRF/BRF Thermostat,
simultaneously press &
hold the , &
buttons .
Descriptions, default values and value ranges for each thermostat function are listed on the following page.
Setting Device Parameters
2 . Press the up arrow
for menu #49 .
Press confirm
3 . SEL –
Press confirm
4 . US
E
Press confirm
5 . Use &
to change the parameter id (d##) .
Use
.
the parameter value .
6 . Pressing confirm
.
to the next function .
7 . Press confirm
.
d19 to return to main screen .
or confirm key
& to change
advances
on function
7 .2