Salus SG888ZB System Manual page 46

Section 5
Each AS20WRF/BRF Thermostat is capable of controlling up to 6 ARV10RFM Actuators. All Actuators
intended for pairing with a single thermostat are to be in pairing mode before proceeding
7 . When the AS20WRF/BRF
Thermostat displays
, press confirm
.
10 . When all Thermostatic Regulator Valves (TRV) have been set up, press & hold the pairing button
on the AC10RF Coordinator or the multi button on the SG888ZB Gateway to complete pairing .
When the AS20WRF/BRF Thermostat is successfully paired, the screen will display the current
temperature, the LED indicator on the ARV10RFM Radiator Valve Actuator turn off and, if applicable,
the LED back light on the AX10RF Receiver's Auto/Manual switch will appear solid red . The LED on the
AC10RF Coordinator will be solid red . If the SG888ZB Gateway is used without an internet connection,
the LED ring on the multi button will be solid red .
LED is off.
Use the Identify Mode to check system communication and configuration.
1) Press and release the AC10RF Coordinator button to enter Identify Mode. The light will flash green.
Each item connected will give an indication that it is connected.
a. AKL-RF Wiring Center – G1 & G2 flash red
b. AX10RF Receiver – On/Off Switch backlight flashes green
c. AS20WRF/BRF Thermostat – Displays a 10 minute countdown with the letters "id" below it
until identify times out.
2) Press and release the AC10RF Coordinator button to exit Identify Mode. The light will change to solid
red indicating that the network is active
Device Pairing & Setup without Internet
8 . Press right arrow
to begin scanning for
ARV10RFM Actuators that
are in the pairing mode .
1 2 3 4 5 6 7
9 . Once all Actuators have
been scanned, press
BRF Thermostat to pair the
valves with the Thermostat .
LED is solid red.
PM
on the AS20WRF/
Auto Manual
On Off
5 .6