Awrt10Rf Pairing With Internet Connection (Sg888Zb Gateway); Pairing With Akl01/04/06Prf And Akl08Rf Relay Controllers - Salus AX10RF System Manual

Section 4
After the initial boot up sequence on the initial power up, the AWRT10RF immediately enters the
pairing process . Using the
DEVICE
Relay Controller
Radiator Valve
Receiver (RX1)
Receiver (RX2)
To connect the AWRT Wireless Radiant Thermostat and other components using an SG888ZB Gateway,
the gateway must be installed and activated. Please see the
(https://www.salusinc.com/wp-content/uploads/2017/10/BZG_IUG-ENv4.pdf)
setting up the gateway.
Pairing with AKL01/04/06PRF
and AKL08RF Relay Controllers
Before pairing, the AKL Series Relay Controller and optional AX10RF Receiver (if desired) must be
installed and powered in accordance with installation instructions included with these devices .
• The LED ring on the SG888ZB Gateway should be solid blue
• The Network Status LED on the AKL Relay Controller should be flashing
• If an AX10RF Receiver is used, the LED backlight on the Auto/Manual switch of this device
should be flashing red and the switch should be in the Auto position
Step 1. If
displayed and flashing, use the
keys to display it . Press the SELECT key
on the AWRT10RF Thermostat .
AWRT10RF Pairing with
Internet Connection (SG888ZB Gateway)
and key to select between the following devices:
is not
or
MODEL(S)
AKL01PRF
AKL04PRF
AKL06PRF
AKL08RF
ARV10RFM-3
AVA10M30RF
AX10RF (RX1)
AX10RF (RX2)
SALUS SG888ZB Installation Instructions
The display will show JOINING- - - with a 10 minute
countdown timer to show how much time is
available to complete the next steps . The icon will
flash at the bottom of the screen indicating that the
thermostat is searching for a network to join .
DISPLAY
for information about
4 .1