As20Wrf/Brf Thermostat With Ax10Rf Receiver For Zone Valve Operation (Rx2) - Salus SG888ZB System Manual

Section 5
4 . When Thermostat
displays
confirm
6 . Once the display shows the current temperature, confirm that the LED back light on the Auto/
Manual switch is a constant red . The AX10RF Receiver is now paired .
AS20WRF/BRF Thermostat with AX10RF Receiver
for Zone Valve Operation (RX2)
Be sure the switch on the inside cover of the AX10RF Receiver has been configured to RX2, for zone
valve operation and the receiver has been wired as indicated in Section 3, Installation . To begin
pairing, all of the required components are to be powered: AS20WRF/BRF Thermostat and AX10RF
Receiver . The lighted LED button on the AC10RF Coordinator should be solid red . The switches on
the cover of the Receiver should be in Auto and On positions respectively .
Each wireless system will support only one receiver in RX1 mode and one in RX2 mode. These
two components can be used together to provide boiler switching and zone valve operation.
Device Pairing & Setup without Internet
5 . When the display shows
, press
.
, press confirm
.
Auto Manual
On Off
PM
1 2 3 4 5 6 7
The AS20WRF/BRF Thermostat will
display the current temperature
and an icon showing the
temperature mode .
5 .8