Salus SG888ZB System Manual page 43

Section 5
3 . After choosing the correct thermostat
configuration, the AS20WRF/BRF Thermostat
displays "rL AY" at the bottom of the screen .
Press to continue . The "rL AY" selection is
used for all AKL Wiring Centers . Note: that older
firmware may display "UF H" instead of "rL AY"
5 . Wiring Center Number:
Use the or
buttons to
choose the Wiring Center
number if there are more
than one in the system .
Then press confirm
Device Pairing & Setup without Internet
6 . Group Number: If grouped
thermostats are used, use
the up arrow to choose
either group 1 or 2 . If no
groups are used, leave "_ _"
blank for this parameter .
.
4 . When the screen reads
to proceed with the AS20WRF/BRF
Thermostat setup .
7 . Zone Number: Use the
to choose the heating zone
to which the AS20WRF/BRF
Thermostat is to be associated .
Then press confirm
, press confirm
or buttons
.
5 .3