Salus SG888ZB System Manual page 29

Section 4
Next we will complete the AS20WRF/BRF setup sequence .
13 . Wiring Center Number:
Use the
buttons to
choose the Wiring Center
number if there are more
than one in the system .
Then press confirm
The Group setting is not used for wireless systems connected to the internet. For information on
using Groups, see the section entitled "AS20WRF/BRF Pairing without Internet Connection."
If multiple identical components are used, it is important to give each a unique identification. For
example, if more than one AS20WRF/BRF Thermostat is used, name each one for the zone with
which it is associated. For example, AS20WRF-1st Floor helps to identify which thermostat you are
interacting with when you use the application.
16 . Once the pairing is complete, the AS20WRF/BRF Thermostat shows the current time & temperature .
Increase the temperature setpoint above the current temperature to test operation . The zone light
corresponding with the thermostat being tested should come on . If an AX10RF Receiver is used,
the backlight behind the Auto/Manual switch will be solid green, indicating
that a demand signal is going to the boiler . Check to be sure the boiler starts when this demand
is present .
When the thermostat is successfully paired, the screen on the AS20WRF/BRF Thermostat will display
the current time and temperature, the Network Status light on the AKL-RF Series Wiring Center will
be solid green and, if applicable, the LED back light on the AX10RF Receiver's Auto/Manual switch will
appear solid red. The LED ring on the SG888ZB Gateway will be solid blue.
Device Pairing & Setup
with Internet Connection
14 . Group Number: Group
or numbers are not applicable
to wireless systems
connected to the internet .
Leave "_ _" blank for this
parameter .
.
15 . Zone Number: Use the
or
to choose the heating zone
to which the AS20WRF/BRF
Thermostat is to be associated .
Then press confirm
buttons
.
4 .8